View Full Version : No process plates

02-15-2007, 01:50 PM
I'm currently one of the few, if not the only facility in my area using these, and have had feedback from only Kodak. I would love to hear some feedback from other users. We have been using them for two years now on sheetfed. (They are working great for us BTW)

02-28-2007, 01:16 PM
We have been using the Kodak Thermal Direct for 8 months. They work pretty well though it is hard to diagnose problems with them. They are also a lot more sensitive out on the floor.

08-01-2007, 08:53 PM
We have been using TDP since Nov of 2005 and havent had any problems with the plates except for a haloing problem with the plates. After many tests i basically found that humidity was the culprit. our plate room is temp and humidty contolled but the correct amount of humidity should be about 40-45%. This still allows the sheets in between the plates to release as they are adhered by static. Screen is still working on a solution to the problem.