PDA

View Full Version : 2 optimizing requirements for the same Prinergy job


rwilsondum
10-28-2010, 09:05 PM
I have a prinergy job that prints on both a #3 coated and a #5 coated substrate. I want to curve and ink optimize plates for both print conditions. With ColorFlows 'one colorsetup' limit within job attributes, must I create 2 prinergy jobs to optimize for both print conditions on final output?
Thanks

david.herder
10-28-2010, 10:47 PM
You can refine your input files with any Color Setup that you like that is different (or the same as) your Job Default Color Setup. This allows you to have mixed Color Setups for many signatures within a single job.

However, there is one thing to be aware of at the moment. If you are color matching or calibrating imposition marks, the mark received the Color Setup information from the Job Default Color Setup. So, if you do need to apply color management or calibrate imposition marks, then on output, switch your Job Default Color Setup (in the Job Attributes) to match the Color Setup of the surface that is being output.

regards,
dave