PDA

View Full Version : Moving Harmony Curves and incorporating a Plate Curve


mark_jetzer
12-03-2011, 04:49 PM
We have 2 Magnus 800 platesetters. When plating with have a Plate Curve we use that linearizes the each platesetter. While both devices are very stable and close linear on their own, we use the Plate curve to adjust for the minor differences we have seen. It not uncommon for us to have a full set of plate made off one device then a remake off of the other during a production run.

What is a suggested way to incorporate this type of setup with Colorflow? Or should we linearize the Magnus in some way outside of Colorflow?

This also ties to our Flexo workflow, where we use a plate curve for the different Flexo plate material.

eduardo
02-08-2013, 05:00 PM
Hi Mark

How did you make your plate setup? I work with 2 different plate brands with 2 different curves. I would like to change the plate curves without to lost the the entire colorflow setup.

This was possible this using the curves in Plate Line.

I'm correct?

Thanks